This product listing is for 20 clear stands. Our modern figure stand is designed for 4″ action figures such as GI JOE (25th Anniversary and forward), modern Star Wars, Marvel Universe, Iron Man, Captain America, Indiana Jones, Forces of Valor, and any other action figure which utilizes 0.10″ (2.5mm) holes in the feet for use with display stands. Many smaller scale action figure brands are standardizing on this size. The most versatile stand on the market for modern action figures featuring four pegs to accommodate the widest variety of dynamic poses while still keeping two feet firmly attached to pegs. This allows dynamic and stable poses for even the most stubborn, unbalanced action figures – especially those with large and heavy accessories. Our stand has two wider spaced pegs closer to the center, then two more closely spaced pegs near the edge. You can pose a figure on the any combination of pegs that you like depending on the stance desired. Further, the closely spaced pegs are available either closer to the left or to the right side of the stand which allows for even variety of posing configurations. See the red arrows in the diagram below which points out the positioning of edge pegs. Shipments will contain roughly a 50/50 mixture of stand with the alternating edge peg configuration. For vintage GI JOE (pre-2007) and other figures, see our vintage figure stand. Dimensions in inches: 2.57″ (L) x 1.735″ (W) x 0.130″ (H). Peg is 0.10″ tall, diameter is 0.10″ Dimensions in centimeters: 6.52cm (L) x 4.4cm (W) x 0.33cm (H). Peg is 2.5mm tall, diameter is 2.5mm PLEASE NOTE: stands are for 4″ action figures, will not work with 6″ Marvel Legends, Star Wars Black, etc.